Ok it's all done this is pic of regular factory thumb.
This is pic of repaired thumb
You can tell difference because it being slightly fatter but in display it cannot be noticed.
Ok it's all done this is pic of regular factory thumb.
This is pic of repaired thumb
You can tell difference because it being slightly fatter but in display it cannot be noticed.
I'm working on something new. I'm working on a lift ticket mic replacement.
This is a test fit without final paint.
ok well i posted this on customs but i thought it actually belongs here in the vintage section becouse its for a vintage figure. here is my custom hand made cobra commander thone chair. i will be making diffrent styles but for now i think works.
Are there any good methods to touching up the paint on old figures? I don't mean a complete custom job, just a touch-up to hair/uniform/boots that have been scuffed. Any advice would be greatly appreciated.
Thanks.
Quick one on loose rotating arm joints: Can the lower arm be safely pulled off? What's the top solution? Going with Elmer's for the easy fix, for now... I have a Steel Brigadesman who needs rehab.
Hey guys I just found a drill out extractor bit that is perfect for rusty or stripped screws. I have done about 10 figures so far nice and easy. Pricing P125S #5 & #6 M3 Skin Wrapped on
Dim. 4"x2.5"x.5" 1 0.015 7 27708 00125 1 $14.86 not sure if you can buy them at a brick and mortar store or not. I have seen the bigger ones but not micro size. its drill out brand, try drillout.com. My link didnt post
Only 346 more figures to go. LOL
very good tips and tricks. you guys probably all know this but the scotch tape trick helps tighten loose joints. i use it on shoulders and knees
Bookmarks