I keep forgetting to mention this on here because I feel like a dumb@$$ for doing it, but if it can help anyone avoid the mistake I did then I guess its worth it . its very easy to find a MOBAT in any condition just about any where, yard sales, flea markets & eBay . of course most of us know the battery cover & the little machine gun on the turret are the hardest things to find, unless your looking for a MOBAT with very good if not excellent sticker placement. well I found one but the motor didn't work so I wanted to do the switch -a- roo with it to get in to better condition. its very easy to dis assemble the tank & put it back together, the mistake I made was in the re assembely. the very front two screws in the front of the tank (on the bottom side ) is where I screwed up. I over tightned them to the point where they but stress marks on the top side of the tank (basicaly 2 white dots in about the worst place) I honestly don't think I put them in very tight , but I was dead wrong ! so upon reassembly please use care to just make the screws "snug" it may not seem as if its enough but I assure you it is. I hope this helps someone avoid the problem I had. So has any one else done this mistake ? just curious
Bookmarks